@article{oai:repo.qst.go.jp:00079287,
 author = {Murakami, Haruyuki and Tsuchiya, Katsuhiko and Kizu, Kaname and Hamada, Kazuya and Nomoto, Kazuhiro and Itashiki, Yutaro and Haruyuki, Murakami and Katsuhiko, Tsuchiya and Kaname, Kizu and Kazuya, Hamada},
 issue = {4},
 journal = {IEEE Transactions on Applied Superconductivity},
 month = {Jun},
 note = {The mechanical loading technology has been developed for the pre-compression of central solenoid for the tokamak device of JT-60 super advanced (JT-60SA) being constructed in Japan. Four central solenoid modules were manufactured one by one, then 4 modules were stacked. The pre-compression were conducted to bind stacked 4 modules by support structure called tie-plate as a final process of the central solenoid manufacturing. The pre-compression jigs were designed by using the finite element analysis taking into account of plastic deformation of the jigs and the tie-plate. The pre-compression was performed using developed
jigs.The hydraulic jacks and pumps were separately installed to the each tie-plate to control the pre-compress load individually. Since the pre-compress load changed by insulation creeping after initial loading, additional shims were inserted for the tie-plate with small load. Finally, pre-compress load of all tie-plate became within the target range. These results indicate that the pre-compression has been successfully completed using the developed jigs. In this paper, the design and analysis of the pre-compression jigs and the result of the pre-compression are reported.},
 title = {Mechanical Pre-Compression System of the JT-60SA Central Solenoid},
 volume = {30},
 year = {2020}
}