量研学術機関リポジトリ「QST-Repository」は、国立研究開発法人 量子科学技術研究開発機構に所属する職員等が生み出した学術成果(学会誌発表論文、学会発表、研究開発報告書、特許等)を集積しインターネット上で広く公開するサービスです。 Welcome to QST-Repository where we accumulates and discloses the academic research results(Journal Publications, Conference presentation, Research and Development Report, Patent, etc.) of the members of National Institutes for Quantum Science and Technology.
Thank you very much for using our website. On the 11th of March 2019, this site was moved from our own network server to the JAIRO Cloud network server. If you previously bookmarked this site, that bookmark will no longer work. We would be grateful if you could bookmark the website again. Thank you very much for your understanding and cooperation.
The construction of a full-superconducting tokamak referred as JT-60 Super Advanced (JT-60SA) is in progress under the JA-EU broader approach projects. The magnet system of JT-60SA consists of 18 toroidal field (TF) coils, 4 modules of central solenoid (CS) and 6 equilibrium field (EF) coils.
CS modules are manufactured one by one, then 4 modules are stacked. Finally, the pre-compression are conducted as a final process of CS manufacturing.
There are two methods for pre-compression, one is shrink fitting method, and the other is mechanical compress method. The shrink fitting method is simple method for pre-compression because it is not needed additional jig. However it is difficult to control compress load because the height and the amount of shrinkage by compress load of CS module is not completely uniform. In addition, if compress load become reduced, re-compress will be required after starting operation, but re-compress is impossible with the shrink fitting method.
Mechanical compress process was selected for pre-compression of JT-60SA CS to avoid above problems. Nine sets of hydraulic jacks and compress jigs, and stainless steel shims were used for pre-compress process to subject compress load by mechanically. Compress load of each sector can be controlled independently with this method. And re-compress after starting operation can be conducted. It means hydraulic jacks and compress jigs can be inserted from manhole of cryostat.
Pre-compression of CS module was successfully performed using mechanical compress process. The compress load of each sectors measured by strain gauges on tie plates was more than requirement of 4.2 MN/sector.
In this paper, procedure and result of pre-compression with mechanical compress process will be described.
会議概要(会議名, 開催地, 会期, 主催者等)
第26回国際磁石技術会議(MT26 International Conference on Magnet Technology)